LP560-4: Bumper & Intake 4

A little update. Another effort of puttying and sanding.

Also open up the side brake intake on both sides, some plastic boards have to be prepared to simulate the brake intakes shapes. Some more work to be done.

This build is a detail comparison of the older Gallardo with the new LP560-4. Higher degree of accuracy and planning should be readied. Actually I started the rear of the body, quite a lot have been changed, even the chassis and the body are going to gether differently than the old one.

Recently, only a tiny little part can be done every other day even on weekends... really want to spend say a whole day on this but seems not possible...a modeler's dilemma.

LP560-4: Bumper & Intake 3

Another little update to the bumper...
Lower part of the bumper was chopped off and the intakes on both sides were fixed to the bumper. Using AB putty, the new bumper/intake sides are ready.

With the some priming and sanding, the basic shape is there. A lot of work to go...

Here's a pic of the underside of the intakes...