LP560-4: Bumper & Intake 5

There werer still some minor modification on the sides of the bumper. The openings were done and some efforts was needed to shape them up:

Hope these vents can be done in a couple of days when layers of putty are dried completely.



The diffuser had not be completely designed but may finish the independent interior and engine first...

LP560-4: Rear Bumper 2

Since the kit based on was a Fujimi Gallardo "Deluxe Version", came with some PE upgrade parts such as the brake disc, license plate and front/rear grille. But the new Gallardo would be much different from the old at the rear, so try to look up see if there is any after-market LP560 parts such as the rear grille, only the Acu Stion PE which doesn't really help:

Anyway, I go for building from plain hexagonal meshes. In an LHS, picked up the Hasegawa ones, seems the scale (large size) is pretty close to the one needed. Give it a try, why not?!

A template on the mesh had been made and thinking of how the grille to be installed on the tail...
Refer back to a extra high definition picture taken closely at and thru the grille, some supports were at the back to mount that mesh on. So decided to build something like that. If it's too obvious, these would be trimmed:

Finally the rear end of the body was trimmed. Diffuser would be a tough task and need some planning before hand...

LP560-4: Rear Bumper 1

Some works had been started on the rear bumper of the body.

- the 2 vertical connection of the grille were removed

- the tail lights were widened

- original tail light vertical parts were removed

- the license plate area removed

It's debatable whether the license plate area to be removed. I'd struggled for a while but finally decided to cut it out. The reason was the the whole panel of the exhaust and the part can be done via a single back panel of styrene board, the measurement can be easier and much aligned, I hope :)

Of course, the basic work needed to be done on the body such as the deepening of panel lines, removing mold lines and flattening of parts with shrinkage when molding. Work goes on...

s204: Front Spoiler

Putting the front grille PE on the front spoiler. The subaru decal should not be put directly on the PE but instead it should be protruding outward from the grille. Cut and trimmed a piece of plastic rod, sand it to the same size as the decal and put it on.

Scratch built an external grille and painted black, not sure if it fits the overall body look, anyway, it can be stick to the spoiler last minutes...

(15/6/2009)

s204: Bumper

趁中間有個空檔，翻看一寫參靠資料。看見這幅相片裡的前擋，那個網蠻有型哦，就試試看

用膠紙貼在Bumper上，畫出雛形，專貼到膠片上，剪出需要的形狀。打磨OK後，再用模型用剩的車頭膠網，貼到框的背後