LP560-4: Rear Bumper 1

Some works had been started on the rear bumper of the body.

- the 2 vertical connection of the grille were removed

- the tail lights were widened

- original tail light vertical parts were removed

- the license plate area removed

It's debatable whether the license plate area to be removed. I'd struggled for a while but finally decided to cut it out. The reason was the the whole panel of the exhaust and the part can be done via a single back panel of styrene board, the measurement can be easier and much aligned, I hope :)

Of course, the basic work needed to be done on the body such as the deepening of panel lines, removing mold lines and flattening of parts with shrinkage when molding. Work goes on...